Causes and solutions for the increase of molybdenum wire loss during wire cutting Factory Suppliers Manufacturers Quotes

Causes and solutions for the increase of molybdenum wire loss during wire cutting

In the wire cutting process, the loss of wire cutting parts is abnormal, which will increase the production cost, thus reducing the efficiency of your own, which makes your friends have a headache. Friends sometimes encounter the phenomenon of large loss of wire-cut molybdenum wire when doing work. In today's article, I will answer the reasons and solutions for the loss of molybdenum wire in the process of wire cutting by wire cut edm machine.

First, we have to find a few factors:

1. Whether the material of the wire cutting process has changed, is it a material that is relatively difficult to process such as copper, tungsten steel;

2. Also check if the machining current parameters have been changed;

3. Check if the molybdenum wire on the machining path is stuck on the conductive block and the guide wheel. The friction of the stuck molybdenum wire will be large and the loss will be large;

4. Ask if you have purchased fake molybdenum wire because of the small amount of money;

5. Check if the spark is normal during the wire cutting process. Check the main vibration plate. If there is a problem, you need to find a replacement.


Please feel free to give your inquiry in the form below. We will reply you in 24 hours.
WIRE CUT EDM DIE SINKING EDM CNC MACHINING CENTER SURFACE GRINDING MACHINE